Call and
Signal
Menu

Browse by topic

Antennas and Feed Lines

Compare beginner antenna and feed-line choices while keeping installation and RF safety within a modest station’s scope.

Nov 10, 20267 min read

How a Vertical Antenna Radiation Pattern Works

A vertical antenna's radiation pattern describes where its radiated signal is stronger or weaker in different directions. The familiar “doughnut” picture is a useful starting point: a simple vertical can cover directions around the horizon while sending relatively little energy directly overhead. It does not mean the antenna transmits equally in every direction, and it does not guarantee a particular DX range.

→
Nov 7, 20268 min read

Understanding Coaxial Cable Velocity Factor

Velocity factor is the speed of a wave in a transmission line divided by the speed of light in vacuum. A coaxial cable with a velocity factor of 0.66 carries the relevant wave at about 66% of that vacuum speed. At a given frequency, its wavelength inside the cable is also about 66% of the free-space wavelength.

→
Nov 6, 20267 min read

SWR vs Return Loss: Understanding the Difference

SWR and return loss describe the same port mismatch using different scales. Lower SWR is better, with a perfect match at 1:1. Higher positive return loss is better, with a perfect match approaching infinity in the ideal calculation. A 2:1 SWR corresponds to about 9.54 dB return loss and 11.1% reflected power at the same reference plane.

→
Nov 6, 20269 min read

Baluns vs Ununs vs Chokes: Principles and Applications

A balun handles a transition between balanced and unbalanced systems. An unun handles an unbalanced-to-unbalanced transformation. A common-mode choke impedes unwanted current flowing in a common-mode path, such as along the outside of a coax shield. These names describe related but different jobs, and one device can perform more than one job.

→
Nov 3, 20267 min read

Understanding Microphone Impedance in Ham Radio

Microphone impedance describes the electrical behavior of a microphone's output or a radio's microphone input. It matters because the microphone must deliver an appropriate audio signal into the radio's load. However, a matching ohm number alone does not establish compatibility: output level, microphone power, balanced or unbalanced wiring, connector pinout and push-to-talk all matter too.

→