Call and
Signal
Menu

Browse by topic

Station Setup

Assemble and check a low-risk first station with clear prerequisites and stop points.

Nov 11, 20268 min read

How to Choose a Ham Radio Bandpass Filter

Choose a bandpass filter by the unwanted signal you need to reject, the frequencies you need to pass and the power it must handle. A filter that works well ahead of a receiver may fail in a transmitting path. A high-power filter can still be the wrong choice if its passband, rejection or installation position does not address your problem.

→
Nov 7, 20268 min read

How to Set Up Anderson Powerpole Connectors for Field Power

Set up a Powerpole field-power lead by matching the contact to the wire, assembling the housings in a defined orientation, crimping and fully seating each contact, and verifying the completed lead before connecting a radio. The red and black shells make a useful visual convention, but only an electrical check establishes polarity. A correctly assembled connector also needs appropriately protected wiring upstream.

→
Nov 6, 20268 min read

How to Choose and Use an Antenna Switch

An antenna switch selects an RF path between a common connector and one of several other connectors. In a typical small station, it lets one transceiver use a dipole, a vertical or a dummy load without repeatedly moving coax plugs. Choose it for the actual frequencies, power, duty cycle, connector arrangement and switching job. Then label the paths and change position with transmission stopped.

→
Nov 3, 20267 min read

How to Choose Headphones for Ham Radio

Choose ham-radio headphones by starting with the radio's headphone output, then checking speech or CW clarity, connector wiring, comfort and the noise around your operating position. A large frequency-range number or high price does not establish that you will copy a weak call sign more reliably.

→
Oct 31, 20268 min read

How to Set Up CAT Control for a Ham Radio

To set up CAT control, connect the radio's documented computer-control interface, install the required driver, select the matching radio and serial port in one application, and make the communication settings agree at both ends. Prove that you can read and change frequency while the radio stays in receive mode before enabling any computer-controlled transmission.

→